When using imported industrial belts, belt breakage will occur. For this kind of conveyor belt breakage, our Shaofeng Industrial Belt has summarized the following reasons and how to solve or avoid the solution of conveyor belt breakage.
Reasons for the broken conveyor belt:
(1) The tension of the conveyor belt is uneven, or the tension of the conveyor belt is too large;
(2) The conveyor belt has been used for a long time, exceeding the service life of the conveyor belt;
(3) Conveyor belt tearing caused by material impact;
(4) The quality of the conveyor belt joints does not meet the standard and does not meet the requirements for use;
(5) The joint of the conveyor belt is damaged and the teeth are warped;
(6) Conveyor belt runs off, causing unilateral burrs.
Prevention of conveyor belt breakage:
(1) Adjust the tension in the device to avoid excessive tension or uneven tension on the conveyor belt;
(2) Record the use cycle of the conveyor belt in time, and replace the conveyor belt regularly for important sections;
(3) Control the possibility of large pieces of material falling, and reasonably design the gap between the material and the conveyor belt;
(4) Carry out quality inspection for conveyor belt connection to prevent conveyor belt quality problems;
(5) If there is a problem with the joint of the line of defense conveyor belt, deal with it immediately to prevent further deterioration;
(6) Pay attention to the deviation setting of the conveyor belt, and pay attention to the deviation adjustment during operation.
The solution to the broken conveyor belt:
(1) Clean up the falling materials and conveying equipment on the conveyor belt to ensure that the entire conveying equipment is clean and tidy;
(2) Loosen the tensioning device and cut off the damaged part of the conveyor belt;
(3) Calculate how much new material is needed to ensure that the length of the conveyor belt remains unchanged;
(4) Use connecting equipment for thermal connection, or steel buckle type mechanical joints;
(5) Adjust the tension device to ensure uniform force;
(6) Trial run, confirm that the conveyor belt load does not deviate, and put it into operation after normal operation.
